Born out of the need to hold chuck mounted turned work for embellishing.
This is far more than a carving stand. Choose the correct spindle for your lathe and this gives you the option of mounting a woodturning chuck with the same thread onto the Pro-Mount. Turners can screw a freshly turned bowl directly onto the Pro-Mount for embellishment and decoration while the bowl is held in the jaws of the chuck. The Pro-Mount is precision machined from 1045 high tensile steel.
360 DEG. ROTATION - Two independent locking levers means you can rotate your work horizontally as well as vertically offering positive positional locking at any position. The outer lever controls horizontal rotation allowing you to turn your work a full 360 deg. The inner handle controls vertical rotation also 360 deg. There is great advantage in being able to adjust your work one plane at a time.
PROJECT STAYS SECURE – Uniquely features two levers. When unlocking a lever to adjust the angle of your work the chuck, holding your project, stays securely held in the Pro-Mount without the risk of it dropping and damaging your project, which is a risk with other single lever Carving products.
STURDY AND VERSATILE - Once the levers are locked your work will not move and carving or detailing can commence.
LATHE TO CARVING TO LATHE - A freshly turned vessel can be moved onto the Pro-Mount whilst remaining in the woodturning chuck allowing it to then be put directly back onto the lathe to finish turning once completing your embellishment or carving.
VACUUM CHUCK COMPATIBLE - The Pro-Mount spindle uniquely features a machined hole through the centre and a 1/4" BSP thread at its base for an airline fitting. This gives the option of using a vacuum chuck as a means of work holding.
USER GUIDES & VIDEOS SUPPLIED - An extensive user guide booklet is included in the box with your Pro-Mount. User guide and demonstration videos available on our You Tube channel.
INCLUDED: Pro-Mount Body, 1: Tool Post and Chuck Spindle (Size selection available) Note - The 1" tool post with a 1/2 inch UNF, which offers the choice of mounting your Pro-Mount on your lathes banjo. Each lathe requires a different diameter tool post so if you require a different size tool post please contact support@woodcut-tools.com.
Additional purchase available: Bench Stand - The bench stand has machined slots in the base to enable mounting on your bench, wall, milling machine cross slide or pillar drill table. Carvers Plate - The Carvers Plate product is currently on hold as Woodcut Tools spend time on product development. Please feel free to contact support@woodcut-tools.com for further infomation on this.
